...版、英文版） 关键字: 表面摩擦力; 轧制织构; 滑移系; 摩擦学参数[gap=425]Key words: surface friction force; rolling texture; slip system; tribology parameters...
基于100个网页-相关网页
...粒在空 间取向上呈现出规律性） （2）类型及特征 ① 丝织构（fiber/wire texture）及特征：用表示 ② 板织构（rolling texture）及特征：用｛hkl｝表示 多晶体中，晶粒滑移时，也伴随着晶面的转动。使滑移由滑移方向转向与轴平行。
基于8个网页-相关网页
The following are important results:（1）The finished alloy sheets of Al-Mg-Mn produced by cold roll and annealing for stabilization has {110}<112> rolling texture and {100}<001> cubic texture. The indexes of in-plane anisotropy of Al-Mg-Mn alloy sheet reduced by {100}<001> texture.
得到了以下重要结论:（1）Al-Mg-Mn合金冷轧-退火成品板材具有{110)<112>轧制织构和{100)<001>再结晶织构组态,立方再结晶织构的出现降低了Al-Mg-Mn合金的平面各向异性。
参考来源 - Al·2,447,543篇论文数据，部分数据来源于NoteExpress
Big ferrites and hot rolling texture are left behind in particle structures, Which leads the anisotropy of mechanics, so the tensile strength and elongation rate reduce.
含有粗大的铁素体晶粒和残留的热轧织构，引起力学性能的各向异性，导致了抗拉强度和延伸率的降低。
The results showed that the if steel has better deep drawability, higher mechanical and texture strength and elongation if the hot rolling temperature was low with big reduction in ferrite region.
结果表明，较低的铁素体轧制温度和较高的铁素体区压下量时，IF钢具有更高的深冲性能、相对较高的强度、延伸率以及织构强度。
The emphasis is put on effect of purity homogenization, hot rolling temperature, cold rolling and medium annealing on cubic texture of finally annealed foil.
重点研究了铝的纯度、均匀化制度、热轧温度、冷轧及中间退火对最终退火后箔材形成立方织构的影响。
应用推荐